Satisfaction Guarantee Contact Us About Us
Home Products Order Now Resource Center Helpful links

 Latest News
Veterinary ECG and CO2 NOW AVAILABLE!

 

 

 

The CO2 Module incorporates a mainstream type of CO2 sensor for use on intubated patients and allows the petMAP+II to display the capnograph as well as the CO2 values:  ETCO2 (End Tidal CO2), InspCO2 (Inspired CO2), RtCO2 (Realtime CO2) and RRCO2 (Respiration Rate from the CO2 waveform).  The CO2 sensor resides on the airway and has a nine-foot cable that plugs into the connector labeled “CO2” on the side of the petMAP+II.  The Module includes two airway adapters, one for larger endotracheal (ET) tubes and one for smaller ET tubes.

Use of the ECG Module allows the petMAP+II to display an ECG waveform and the HR derived from the ECG signal.  The ECG Module is connected to a flat five-foot cable that plugs into the side of the petMAP+II .  The Module has connections for three surface ECG lead wires and an esophageal probe that has ECG electrodes on it (sold separately).  Only one set of ECG electrodes can be used at one time.  The user can switch between surface leads and the esophageal probe using a slide switch on the ECG Module.  The user can also adjust the gain on the ECG waveform using a slide switch on the ECG Module. 

 

 

Home Products Order Now Resource Center Helpful Links Satisfaction Guarantee Contact Us About Us Sitemap
petMAP was developed by Ramsey Medical, Inc.

Copyright © Ramsey Medical, Inc. 2008 - 2017 All Rights Reserved

petMAP is manufactured, sold and serviced by CardioCommand, Inc. and may be available through other distributors.